A60F-2D1 Ultrasonic Anemometer
█ Introduction
A60F-2D1 Ultrasonic Anemometer’s work principle is by ultrasonic transit-time to measure the wind speed. The speed of sound in air speed will stack add speed of the air flow up. If the ultrasonic direction is same as the wind’s, it will speed up; Conversely, if the ultrasonic direction is contrary with the wind direction, it will be slower. Therefore, under the fixed test conditions, the ultrasonic speed in the air and the wind speed function is corresponded. It can be obtained the exact wind speed and direction by calculating. Because sound spread through the air, its speed greatly influenced by temperature. The Anemometer detects 2 channels on the two opposite directions, so the temperature impact on the speed of sound is negligible.
The Anemometer has the feature of light weight, no moving parts, durability. And again, no need maintenance and on-site calibration, wind speed and direction can also output at the same time. If necessary, customers may select wind speed unit, the output frequency and output format, may also select the heating device (recommended in the cold environment) or analog output. It can connect with computers, data acquisition, or other RS485 or analog output consistent with the collection of equipment. If necessary, you can also form a network of multiple to use.
A60F-2D1 Ultrasonic Anemometer is an advanced equipment of wind speed detection. Because it can overcome the inherent defects of mechanical anemometer, it can work in whole day, long time. it gets more and more widely used and is a powerful replacement of mechanical anemometer.
█ Applications
● City environmental monitoring
● Wind power generation
● Weather monitoring
● Bridges, tunnels
● Sailing ship
● Airports
█ Features
● No limit to Start wind speed, 360 ° operation, and measure wind speed, wind direction, temperature.
● Work whole day, free from rain, snow, frost, weather
● High accuracy; stable
● Strong, resistant corrosion, installation and use without fear of damage;
● Design is flexible, lightweight, portability, easily installation or undo;
● Easily signal access, while provide both analog and digital signals;
● No need maintenance and on-site calibration.
█ Technical parameter
Wind speed
Model No. |
A60F-2D1 |
Measuring range |
0-60 m/s |
Unit |
m/s |
Accuracy |
±0.2m/s(Wind speed: within 0~5m/s)
<measured value’s 2%(Wind speed:>5m/s) |
Resolution |
0.01 m/s |
Wind direction
Measuring range |
360°around, non-blind area |
Unit |
degree |
Accuracy |
±2° |
Resolution |
1° |
General parameter
Size |
Height×Width=400×265mm |
Weight |
2.5kg |
Material |
Stainless steel (316L) |
Protection level |
IP66 |
Temperature range |
-40°C ~+70°C |
Humidity range |
R 5%~100% |
Ice resistance |
Refer to MILSTD810E |
Corrosion resistance |
After 3 months of salt spray and condensation test, no corrosion |
Dust-proof |
Refer to MILSTD810E |
EMC |
IEC61000-4-5 |
Power |
Work Power: DC24V/60mA
Heater Power: DC24V/5A |
Output signal
Digital signal |
RS 485 |
Baud rate |
9600 |
Analogue signal |
4-20mA |
Output frequency |
15 times /second |
Others
Installation |
Refer to 4.6 Mechanical equipment |
Connection |
Eight-pin connector |
|